Check Energy Efficient Ethernet

Check that Energy Efficient Ethernet configuration works as expected.

  1. Check initial EEE active state on Tester.

  2. Make sure that EEE is enabled on Tester.

  3. Check that connection over the IUT interface works fine when EEE is enabled or disabled on IUT and EEE active state on Tester is set accordingly.

  4. Disable TX LPI on Tester interface.

  5. Disable TX LPI on IUT and check ping time.

  6. Enable TX LPI with big timer delay on IUT and check ping time.

  7. Enable TX LPI with small timer delay on IUT and check ping time.

Dmitry Izbitsky Dmitry.Izbitsky@oktetlabs.ru

Parameters:

env

Testing environment: