.. index:: pair: group; Setup Rx queue at runtime .. _doxid-group__usecases-runtime__rx__queue__setup__with__rss: Setup Rx queue at runtime ========================= .. toctree:: :hidden: group_usecases-runtime_rx_queue_setup_with_rss-run.rst Setup Rx queue when device is started, perform the check using RSS Make sure that it is possible to setup a Rx queue when the Ethernet device is started. Perform the check using RSS RETA. #. Configure the Ethernet device #. Prepare desired RSS hash configuration #. Check for Rx queue runtime setup capability #. Setup the queues that were not marked for runtime setup #. Start the device #. Stop and start the device again to make sure that the device can be stopped while some of its queues are not set up #. Prepare **tmpl** for test #. Get default RETA configuration which implies that all queues are setup #. Prepare template for packets which would have been received on **rxq_runtime_setup_idx** queue if RETA had been configured by default #. Establish effective RSS hash configuration #. Configure RETA to redirect all packets to only setup queues #. Ensure that interface is UP on Tester side #. Check that a packet with the prepared template is received on one of the setup queues #. Setup the **rxq_runtime_setup_idx** queue #. Restart the device to start all Rx queues except **rxq_runtime_setup_idx** queue if **deferred_start** is ``TRUE``. Also make sure that the current state of the queues does not cause device start and stop failures #. Start the **rxq_runtime_setup_idx** queue if **deferred_start** is ``TRUE`` #. Reset RETA to default state #. Check that a packet with the prepared template is received on the **rxq_runtime_setup_idx** queue .. rubric:: Parameters: .. list-table:: :widths: 20 80 * - tmpl - Traffic template * - nb_rxq - Rx queue count * - rxq_runtime_setup_idx - Index of the queue that will be setup and started at run time * - deferred_start - Does the runtime setup queue need to be marked as deferred | :ref:`runtime_rx_queue_setup_with_rss`